Start date: 08/01/08
End date: 07/31/09
About the research
Most bituminous adhesives or binders that are used for pavement materials are derived primarily from fossil fuels. With petroleum oil reserves becoming depleted and the drive to establish a bio-based economy, there is a push to produce binders from alternative sources, particularly from biorenewable resources. However, until now, no research has studied the applicability of utilizing bio-oils as a bitumen replacement (100% replacement) in the pavement industry.
The main objective of this research was to test various properties of bio-oils in order to determine the applicability of using bio-oils as binders in the pavement industry.
The overall conclusions about the applicability of using bio-oils as bio-binders in the pavement industry can be summarized as follows:
1. Bio-oils cannot be used as bio-binders/pavement materials without any heat pre-treatment/upgrading procedure.
2. Current testing standards and specifications, especially Superpave procedures, should be modified to comply with the properties of bio-binders.
3. The temperature range of the viscous behavior for bio-oils may be lower than that of bitumen binders by about 30°–40°
4. The rheological properties of the unmodified bio-binders vary in comparison to bitumen binders, but the rheological properties of these modified bio-binders change significantly upon adding polymer modifiers.
5. The high-temperature performance grade for the developed bio-binders may not vary significantly from that of the bitumen binders, but the low-temperature performance grade may vary significantly.
Report: Development of Non-Petroleum Based Binders for Use in Flexible Pavements (TR-594) (4.56 mb pdf) October 2011
Tech transfer summary: Development of Non-Petroleum Based Binders for Use in Flexible Pavements (TR-594) (176.72 kb pdf) Oct 2011
- Iowa Department of Transportation
- Iowa Highway Research Board